Extreme Revere Ware handle repair

Here is a project sent to us by a customer.  He was determined to fix a friends favorite sauce pan that had been without a handle for 20 years.  The problem was not only that the particular style of handle (the type used in the first few years of production) was not available, but that most of the metal that the handle attaches to had broken off.  This just goes to show that perhaps NO piece of cookware is beyond repair to the truly determined.

We have documented a simple if imperfect adaptation of the vintage style handle we DO sell to the early production pans, but for those looking for a better solution, this project should be inspiration; it is clearly possible to modify the spline that the handle attaches to to fit the “newer” vintage style handles we DO sell.

Thanks to Jim for documenting this project and sending it to us.

Sauce Pan Handle Project

This project involved putting a “Large” sauce pan handle on a “broken” handle stub of an early model Revere Ware 7” sauce pan.

The Problem :

Before: This “early” model sauce pan had a broken handle bracket.

After: Welding  approx. 3” of  ¾” x.065” stainless steel strip to the handle .

This is the finished handle fix –

Note:  The original -early model- right tab was wider than ¾” and had to be ground away to match the ¾” wide stainless strip added to fit the ¾” wide handle niches.

Note:  The dimensional detail of the added piece was accomplished by creating a piece of  light cardboard that fit the handle recesses and then transferring that to a thing piece of sheet metal and from that, it was transferred to the stainless piece for the handle. .

Left Side Detail:

Left Side A. The Left Side tab was basically unchanged.  However, we did weld the left tab to the new handle material for the purpose of strengthening the entire handle system.

Left Side B.   Blue Tape indicates the area of bakelight removal in the handle halves.

Note:  The black marker over the original strengthening rib where the handle is attached to the pan.  This rib interfered with the handle and therefore required some relieving of the handle with a Dremel tool to get clearance and allow the seam of the handle halves to mate up without a crack between them. (  See Blue Tape – Above  )

Left Side C.

Also the left side handle had to be relieved ( notice the semi-circle of blue tape ) and some of the handle cut away where the Tab was welded to the new handle material.

( See Blue Tape – Above  )

Right Side A.

The right side tab of the handle required the Tab be ground away so it was only ¾” wide to match both the new handle extension width and the bakelite handle niche.  Also bakelite had to be removed at the front of the handle where the strengthening rib interfered with the handle fitting flush to the tab.

( See Blue Tape — Above )

Right Side A.

This piece of .040” thick  x  ¾” wide  thick sheet metal was cut to fit the handle and used as a pattern for the shearing of the stainless piece that was .065″.

The stainless piece was then welded to the handle and ground flush.  Then the hole for the hanging ring was drilled after the handles were mounted and fitting well. The result is below.   ( The black line being the weld joint area. )

The Finished Pan….

The project was not all that involved and went quite smoothly.   Sheet metal snips, Dremel tool,  bench grinder, files, dial calipers, vice  and drill were the home shop tools involved.  I did take the stainless strip to a metal shop for shearing and welding.